GreenWorks 2000 PSI - Assembling the Wheel; Assembling the Gun Holder

EN - 12
ASSEMBLY
ASSEMBLING THE WHEEL (See Figure 3.)
■ Insert the axle through the wheel and through the frame.
■ Slide the washer over the axle pass the pin hole.
■ Insert the pin through the hole to firmly fasten the wheel.
ASSEMBLING THE GUN HOLdER (See Figure 4.)
■ Line up the screw sleeves with the holes in the upper handle and push through.
■ Insert the screw and turn clockwise with a phillips head screw driver (not included) until the screw is
tight.
Fig. 3
Axle
Wheels
Washers
Pins
Fig. 4
Axle
Screws
Gun Holder