GreenWorks 2000 PSI - Assembling the Handle; Assembling the High Pressure Hose

EN - 13
ASSEMBLY
ASSEMBLING THE HANdLE (See Figure 5.)
■ Push and hold the push-pin button on the side of the upper handle assembly (1) as you slide the
handle onto the frame (2).
NOTE: Before use, pull the handle up until the lock button snaps through the locking slots to secure the
handle place.
ASSEMBLING THE HIGH PRESSURE HOSE
■ Take one end of the hose off the holder. (See Figure 6-1.)
■ Turn the crank handle until the hose can be completely removed. Then remove the other end of the
hose from the holder. (See Figure 6-2.)
■ Connect one end of the hose to the water outlet connector, while the other end to the trigger gun.
(See Figure 6-3.)
Outlet
Connector
High Pressure
Hose
Fig. 6-3
Fig. 5
(1)
(2)
Holders
Crank Handle
Fig. 6-2
Fig. 6-1