EasyManua.ls Logo

GreenWorks GPW 2003 - User Manual

GreenWorks GPW 2003
60 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2000 PSI ELLECTRIC PRESSURE WASHER
Read all safety rules and instructions carefully before operating this tool.
IMPORTANT, Retain this manual for future reference!
Owner’s Manual
GPW 2003
TOLL-FREE HELPLINE: 1-888-90WORKS
(888.909.6757)
www.greenworkstools.com
P0803500-01 Rev B

Table of Contents

Questions and Answers

  • S
    schmidtlisaAug 7, 2025
    Why GreenWorks Pressure Washer motor will not start?
    • T
      Tom CooperAug 7, 2025
      The GreenWorks Pressure Washer motor might not start due to several reasons: the On/Off switch is in the “OFF” position - set it to “ON”; the power cord isn't plugged in - plug it in; the electrical outlet doesn't supply enough power - try a different outlet; the pressure washer circuit breaker tripped - allow it to cool, then restart; or the power switch is ON, but the gun trigger isn't squeezed - push the gun trigger to engage the AUTO ON switch.
  • D
    Donna EdwardsAug 13, 2025
    What to do if GreenWorks GPW 2003 motor buzzes but fails to run?
    • F
      figueroastevenAug 13, 2025
      If your GreenWorks Pressure Washer motor buzzes but doesn't run, check the following: the supply voltage is below minimum - verify that only the pressure washer is running on the circuit; the system has residual pressure - turn the unit off, squeeze the trigger to release pressure, then turn it back on; voltage loss due to an extension cord - unplug any extension cords and plug the unit directly into the outlet; or residual friction among components - disconnect the water supply and power on for 2 to 3 seconds, repeating a couple of times until the motor starts. If the pressure washer has not been used for a long period, then No answer.
  • A
    Amy HarrellAug 19, 2025
    How to fix GreenWorks GPW 2003 Pressure Washer when there is no water?
    • C
      Christopher RiosAug 19, 2025
      If there's no water coming from your GreenWorks Pressure Washer, it could be due to the water supply being off – turn it on. Another possible reason is a kink in the garden hose – remove the kink.
  • C
    christopher58Aug 25, 2025
    What to do if GreenWorks GPW 2003 output pressure varies?
    • M
      Matthew WallAug 25, 2025
      If the output pressure of your GreenWorks Pressure Washer varies, it could be due to: insufficient inlet water supply - fully turn on the water and check the garden hose for kinks, leaks, or blockages; the pump sucking air - ensure hoses and fittings are airtight, turn the machine off, and purge the pump by squeezing the trigger gun until a steady water flow emerges; a clogged water inlet filter - remove and rinse it in warm water; supply voltage below minimum - verify that only the pressure washer is running on the circuit; or a calcified gun, hose, or power spray tip - run distilled vinegar through the detergent tank.
  • J
    Jeff JenningsAug 30, 2025
    Why GreenWorks Pressure Washer unit does not reach high pressure?
    • B
      Betty RodriguezAug 30, 2025
      If your GreenWorks Pressure Washer isn't reaching high pressure, consider these potential causes: the garden hose diameter is too small - replace it with a 1” (25 mm) or 5/8” (16 mm) garden hose; the water supply is restricted - check the garden hose for kinks, leaks, and blockages; there's not enough water supply - fully open the water source; the pressure tip hasn't been installed on the wand assembly - add the desired pressure tip to the wand; or the water intake filter is clogged - remove the filter and rinse it in warm water.

Summary

SAFETY INFORMATION

General Safety Precautions

Essential safety guidelines and precautions to follow before and during product use.

Extension Cords

Guidelines for using extension cords safely to prevent overheating and electrical hazards.

Electrical Safety Warnings

Warnings regarding electrocution risk and the use of damaged cords.

General Safety Practices

Comprehensive safety practices covering user behavior, product use, and work area conditions.

Specific Safety Warnings

Covers high-pressure jet dangers and California Proposition 65 chemical warnings.

SYMBOLS

Symbol Definitions

Explanation of symbols indicating potential hazards, operation, and safety alerts.

Signal Word Meanings

Definitions of signal words (DANGER, WARNING, CAUTION) indicating risk levels.

SERVICE

Authorized Service and Warnings

Guidance on authorized service, repair, and necessary precautions before use.

ELECTRICAL

Electrical Connection

Requirements for connecting the pressure washer to a suitable power supply.

Drip Loop

Explanation and illustration of how to create a drip loop for the power cable.

KNOW YOUR PRESSURE WASHER

Component Identification

Diagram and explanation of the various parts of the pressure washer.

Key Operating Features

Explanation of detergent tank, GFCI plug, auto on/off switch, and cord storage.

PACKING LIST

ASSEMBLY

Unpacking and Inspection

Steps for unpacking the product and checking for all included parts and damage.

Assembly Safety Warnings

Important warnings regarding assembly, part replacement, and product modification.

Assembling Wheels and Storage

Instructions for assembling wheels and the power cord storage component.

Assembling Panel, Holder, and Hook

Steps for attaching the front panel, gun holder, and hose hook.

Installing Handle and Spray Wand

Procedure for attaching the handle and connecting the spray wand to the trigger handle.

Connecting High Pressure Hose

Steps for connecting the high-pressure hose to the trigger handle and unit.

Connecting Garden Hose

Steps and precautions for connecting the garden hose to the water intake.

OPERATION

Operation Safety Warnings

Crucial warnings to ensure safe operation and prevent injury or damage.

Product Applications

List of common uses and tasks for the pressure washer.

Detergent Adding and Use

Instructions for adding and using detergent with the pressure washer.

Soap Application

Details on how to apply soap using the low-pressure black spray tip.

Starting and Stopping the Washer

Step-by-step guide for safely starting and stopping the pressure washer.

Using the Spray Tips

Guide to selecting and using different spray tips for various cleaning applications.

Trigger and Tip Handling

Safely changing spray tips and operating the spray wand trigger and lock-out.

Operating the Washer

Detailed instructions for cleaning with detergent and rinsing surfaces.

Moving the Pressure Washer

Steps for safely moving the pressure washer from one location to another.

MAINTENANCE

Maintenance Safety Warnings

Important warnings concerning servicing, cleaning, and contact with chemicals.

Spray Tip Maintenance

Instructions for cleaning and maintaining the spray tips to prevent clogging.

Storing and Winterizing

Guidelines for storing the unit and protecting it from winter damage.

Shutting Down and Cleaning Up

Procedure for safely shutting down, cleaning, and disconnecting the unit.

Taking a Break

Instructions for safely pausing operation during use.

TROUBLESHOOTING

WARRANTY

Warranty Information and Contact

Details on the 3-year warranty, coverage, and contact information for service.

EXPLODED VIEW

PARTS LIST

GreenWorks GPW 2003 Specifications

General IconGeneral
Power SourceElectric
Pressure2000 PSI
Flow Rate1.2 GPM
Motor13 Amp
Hose Length25 ft
Cord Length35 ft
Nozzle TypeQuick Connect
Nozzle Types25°, Soap

Related product manuals