GreenWorks 20022 - Maintenance and Care; General Maintenance Tips; Lubrication Requirements

27
MAINTENANCE
W A R N I N G
When servicing, use only identical GreenWorks™ replacement parts. Use of any other parts may
create a hazard or cause product damage.
W A R N I N G
Always wear safety goggles or safety glasses with side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents. Use a clean cloth to remove dirt, dust, lubricant, grease, etc.
W A R N I N G
Do not let brake uids, gasoline, petroleum-based products, penetrating lubricants, etc., come into
contact with plastic parts at any time. Chemicals can damage, weaken or destroy plastic, which
may result in serious personal injury.
LUBRICATION
All of the bearings in this product are lubricated with a sufcient amount of high-grade lubricant
for the life of the unit under normal operating conditions. Therefore, no further lubrication is
required.