20
ADJUSTING POLE EXTENSION (See Fig. 10.)
Disconnect the pole saw from the power supply.
Rotate the collar counter clockwise to loosen.
Pull the power-head pole off of the extension pole, and remove the extension pole from the
handle pole.
Connect the power-head pole to the handle pole, slide the collar up and rotate the collar
clockwise to tighten.
NOTE: Extend the pole only to the length required to reach the limb being cut. Do not lift the handle
above waist height.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the
pole saw at a length that does not allow you to achieve proper footing and balance at all times.
PREPARATION FOR CUTTING (See Fig. 11-12.)
Wear non-slip gloves for maximum grip and protection.
hand on the rear handle, so your body is to the left of the chain line. Never use a left-handed
(cross-handed) grip or any stance that places your body or arm across the chain line.
Never stand directly under the limb you are cutting.
Be certain the collars are fully tightened before operating equipment. Check them periodically
for tightness during use to avoid serious injury.
OPERATION
Fig. 10
COLLAR
To Next Page
Loading...
