27
MAINTENANCE
CHAIN OILER (See Fig. 21.)
WARNING
To avoid possible serious injury, stop the motor and disconnect from supply power from the pole
saw before replacing the bar, chain, or performing any maintenance operation.
Use a lubricant that is designed for chains and chain oilers and is formulated to perform over
a wide temperature range with no dilution requir
approximately 2 oz (57 g) of bar and chain lubricant into the bar lube reservoir.
NOTE: Do not use dirty, used, or otherwise contaminated lubricants. Damage may occur to the oil pump, bar,
or chain.
Fig. 21
BAR LUBE
RESERVOIR
Min
REMOVE CAP
QUICK-VIEW
OIL INDICATOR
To Next Page
Loading...
