GreenWorks 20192 - How to Sharpen the Cutters

29
HOW TO SHARPEN THE CUTTERS (See Fig. 23-26.)

can only be obtained when all cutters are uniform.


midpoint of the bar. Wear gloves for protection.



steel on each return stroke.



CAUTION:
Dull or improperly sharpened chain can cause excessive motor speed during cutting, which may
result in severe motor damage.
WARNING
Improper chain sharpening increases the potential for kickback. Failure to replace or repair

MAINTENANCE
Fig. 26
Fig. 24
Fig. 25
Fig. 23
CUTTING
CORNER
DEPTH
GAUGE
RIVET
HOLE
HEEL
SIDE PLATE
TOP
PLATE
RIGHT HAND
CUTERS
LEFT HAND
CUTERS
TOE
GULLET