6
SAVE THESE INSTRUCTIONS
GENERAL SAFETY RULES
Check damaged parts. Before further use of the product, a guard or other part that is
damaged should be carefully checked to determine whether it will operate properly and
perform its intended function. Check for misalignment or binding of moving parts, broken parts
and mountings, and any other condition that may affect the operation of the tool. A guard or
other part that is damaged should be properly repaired or replaced by an authorized service
centre unless indicated elsewhere in this manual.
Disconnect the plug from power source when not in use, before servicing, and when changing
accessories.
to the product.
If the power supply cord is damaged, it must be replaced only by the manufacturer or by an
authorized service centre to avoid risk.
Save these instructions. Refer to them frequently, and use them to instruct others who may
use this product. If you loan someone this product, loan them these instructions also to
To Next Page
