4
Problem Possible Cause Corrective Action
Trimmer fails to operate Power turned off Turn power on
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
Fuse faulty/blown Replace fuse
Trimmer runs intermittently Extension cable damaged Inspect cable, replace if damaged
Contact Service Agent
Internal wiring of garden product
damaged Contact Service Agent
Garden product labours Grass too high Cut in stages
Garden product does not cut Line too short/broken off Feed the line manually/automatically
Line can not be fed Spool empty Replace the spool
Line inside the spool entangled Inspect the spool, rewind if necessary
1)
Line keeps breaking Line inside the spool entangled Inspect the spool, rewind if necessary
Trimmer used incorrectly Only trim with the tip of the line,
avoid stones, walls and other hard
objects. Feed the line regularly to
maintain full cutting width.
· Do not connect the machine to the mains socket before it is
completely assembled.
· The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cutting line
to stop rotating before switching “on” again.
· Do not rapidly switch off and on.
· Do not hand bump the line feed as it could be hot.
· Remove any grass from spool cover when changing
line or spool.
· It is recommended to use a approved line. Cutting
performance will vary with different line.
· Use the original spring when replacing spool.
Delivery Scope 1
Connecting the Shaft 2
Mounting the Auxiliary Handle 3
Attaching the Shoulder Strap 5
Connecting the Extension Lead 6
Starting 7
Stopping 7
Working Advice 8
Feeding the Line 9
Replacing the Line Spool 10
Winding Line on Spool 10
Do not dispose of garden products into household waste! Only for EC countries: According to the Eu-
ropean directive 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into
national law, electrical and electronic equipment that are no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Action Figure Action Figure
Mounting and Operation
Troubleshooting
Disposal
Intended use of the machine
–– The Brush Cutter/String trimmer is only intended for cutter grass, weeds, Bushes, undergrowth it should not be used for any
other purpose such as Edging or hedge cutting as this may cause injury.
Rated power -----------------------------------------------1200W
Cutting line feed -------------------------------------Bump feed
No load speed ----------------------------------5300/6500 rpm
Cutting line diameter -------------------------------------2.0mm
Cutting diameter-------------------------------------------45cm
Cutting spool capacity------------------------------------5m
Weight according to EPTA-Procedure
01/2003------------------------------------------------------4.6Kg
Protection class------------------------------------------- /II
Technical Data
EN(
ORIGINAL INSTRUCTIONS)
To Next Page
Loading...
