GreenWorks 2502202 User Manual (English)

Questions and Answers:

V
victorlawsonAug 3, 2025
Why does my GreenWorks Lawn Mower stop while mowing?
- D
  Danny HallAug 3, 2025
  If your GreenWorks Lawn Mower stops during mowing, there might be several reasons: * The blade height could be too low, in which case you should increase the blade/cutting height. * The battery pack may be out of power, so ensure it's charged. * Grass clippings might be attaching to the deck or blade; remove the battery pack and check the deck. * The machine's operating temperature could be too high; allow the machine to cool.
N
Natalie PhelpsAug 7, 2025
What to do if my GreenWorks 2502202 doesn't start?
- K
  Katie GilmoreAug 7, 2025
  If your GreenWorks Lawn Mower doesn't start, here are a few things to check: * The battery capacity might be low, so charge the battery pack. * The bail switch could be defective, requiring a replacement. * The safety key might not be inserted; make sure to put it in.
M
Mr. Mark FisherAug 11, 2025
Why is my GreenWorks 2502202 not mulching correctly?
- E
  Eric TurnerAug 11, 2025
  If your GreenWorks Lawn Mower does not mulch correctly, it could be because: * Wet grass clippings attach to the deck. Wait until the grass dries before mowing. * The mulch plug is missing. Install the mulch plug.
K
Kevin PorterAug 15, 2025
How to fix uneven cutting with GreenWorks 2502202 Lawn Mower?
- K
  Kelly JimenezAug 15, 2025
  If your GreenWorks Lawn Mower cuts grass unevenly, it could be due to: * A rough lawn. Examine the mowing area. * The blade height not set correctly. Adjust the blade/cutting height to a higher position.
K
Keith JensenAug 20, 2025
Why is my GreenWorks Lawn Mower so hard to push?
- A
  Aimee JonesAug 20, 2025
  If your GreenWorks Lawn Mower is hard to push, it could be due to: * The grass being too tall or the blade height being too low. Increase the blade/cutting height. * The grass catcher and blade dragging in thick grass. Empty the grass clippings from the grass catcher.
R
Ryan MooneyAug 25, 2025
What causes high vibration in GreenWorks 2502202 Lawn Mower?
- T
  Teresa ParsonsAug 25, 2025
  A high vibration in your GreenWorks Lawn Mower indicates that the blade is unbalanced and worn. Replace the blade.
M
Michael FoxAug 29, 2025
How to adjust the handle on GreenWorks 2502202?
- M
  Marcus WolfAug 29, 2025
  If the handle of your GreenWorks Lawn Mower is not in position, it's likely because the bolts are not engaged correctly. Adjust the height of the handle and make sure that the knobs and bolts are aligned correctly.

GreenWorks 2502202 Specifications

General

Voltage	40V
Cutting Width	20 inches
Deck Material	Steel
Weight	54.2 lbs
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge	Yes
Brushless Motor	No
Power Source	Battery
Battery Included	No
Charger Included	No