GreenWorks 2506402CT User Manual (English)

Questions and Answers:

M
Mike NicholsAug 4, 2025
What to do if my GreenWorks 2506402CT stops during mowing?
- M
  morgansandraAug 4, 2025
  If your GreenWorks Lawn Mower stops during mowing, there are several potential causes. The blade height may be too low, so try increasing it. The battery pack might be out of power, so ensure it is charged. Grass clippings might be attached to the deck or the blade; in that case, remove the battery pack and check the deck. Also, the operating temperature of the machine might be too high, so allow the machine to cool down.
L
Lee GreenAug 9, 2025
How to fix a GreenWorks Lawn Mower that won't start?
- E
  Elizabeth SnyderAug 9, 2025
  If your GreenWorks Lawn Mower won't start, it could be due to a few reasons. First, the battery capacity might be low, so charge the battery pack. Second, the bail switch could be defective, requiring a replacement. Finally, the safety key might not be inserted, so ensure it is properly in place.
H
Holly NashAug 14, 2025
Why is my GreenWorks 2506402CT Lawn Mower hard to push?
- C
  Chelsea LeeAug 14, 2025
  If your GreenWorks Lawn Mower is hard to push, it could be due to a couple of reasons. The grass might be too tall, or the blade height is too low, so try increasing the blade height. Alternatively, the grass catcher and the blade might be dragging in thick grass, so empty the grass clippings from the grass catcher.
J
James LambertAug 19, 2025
Why doesn't my GreenWorks Lawn Mower mulch correctly?
- J
  Jason BrownSep 12, 2025
  There could be a couple of reasons why your GreenWorks Lawn Mower does not mulch correctly. Wet grass clippings might be attaching to the deck, in which case, wait until the grass dries before mowing. Alternatively, the mulch plug might be missing, so install the mulch plug.
J
Jose GoodwinAug 25, 2025
What causes uneven cuts with a GreenWorks 2506402CT Lawn Mower?
- D
  dtuckerAug 25, 2025
  If your GreenWorks Lawn Mower cuts grass unevenly, it could be because the lawn is rough; examine the mowing area. Another reason could be that the blade height is not set correctly, so adjust the blade/cutting height to a higher position.
D
Dana GibbsAug 30, 2025
How to reduce vibration in my GreenWorks 2506402CT Lawn Mower?
- L
  Lisa WilkersonAug 30, 2025
  If there is a high vibration in your GreenWorks Lawn Mower, the blade might be unbalanced or worn, so you should replace it. Also, the motor shaft could be bent. If so, stop the motor, remove the safety key and battery pack, inspect for damage, and repair the machine before you start it again.

GreenWorks 2506402CT Specifications

General

Type	Cordless Lawn Mower
Motor	Brushless
Deck Material	Steel
Drive Type	Rear Wheel Drive
Power Source	Battery
Voltage	60V
Battery	4.0 Ah
Cutting Height Adjustment	7 positions
Warranty	4-year tool, 2-year battery
Grass Collection	Bag, Mulch
Cutting Width	21 inches