BATTERY CHARGER
CHECKING THE CHARGE
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool. Make sure that the outlet is not turned off.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the surrounding air temperature is not normal room temperature, move the charger and
battery pack to a location where the temperature is between 45
of
and 104°F.
AWARNING
If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light
on the charger may switch on and illuminate ORANGE. If this occurs allow the battery to cool
, outside of the charger from approximately 30 minutes.
CHARGER MOUNTING
1. This charger can be installed hanging on a wall using two screws (not supplied)
2. Locate the placementfor the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws.
4. Drill two holes 2 3/8" (6 cm) on center ensuring they are level.
5. If fastening to drywall use wall anchors and screws to secure the charger to the wall.
==
==
==
==
==
==
==
==
NOT E :
If the battery and the charger won't be used fora long time, please remove the battery
from the'Eharger and pull out the AC power plug.
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS - DANGER: TO REDUCE RISK OF FIRE OR ELECTRIC
SHOCK CAREFULLY FOLLOW THESE INSTRUCTIONS. \
2. Confirm the voltage avaliable at each country location before using the charger.
3. If the sharp of the plug does not fit the power outlet, use an attachment plug adaptor of the proper
configuration for the power outlet.
5
To Next Page
Loading...
