19
OPERATION
To clean:
• Pour detergent in the detergent tank.
• Install the black soap nozzle on the spray wand.
• Start the pressure washer and spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.
To rinse:
• Using the desired nozzle, spray away from the rinsing surface for approximately 10
• Start at the top of the area to be rinsed and work down, overlapping the strokes.
MOVING THE PRESSURE WASHER
To move the pressure washer:
• Turn the pressure washer off. Point nozzle in a safe direction
and pull trigger to release water pressure.
• Disconnect the high pressure hose from the trigger handle.
• Tilt the machine toward you until it balances on the wheels then roll the machine to the
desired position.
OPERATING THE PRESSURE WASHER
(See Figure 10.)
Use only detergents designed for pressure washers. Many detergents may require mixing prior
to use. Prepare cleaning solution as instructed on the solution bottle.
Fig. 14
• Turn off the pressure washer and shut off the water supply .Pull trigger to release water
pressure.
• Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.
• Pull back the quick-connect collar.
• Push the nozzle into place in the spray wand.
• Push the collar forward so that the nozzle is secured properly. Check to see that the nozzle is
secure.
TO DISCONNECT A NOZZLE FROM THE TRIGGER HANDLE ONCE THE CLEANING JOB IS
COMPLETE:
• Turn off the pressure washer and shut off the water supply.Pull trigger to release water
pressure.
• Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.
• Remove the nozzle by placing hand over nozzle then pulling back the quick-connect collar.
Place nozzle in the nozzle storage area on the trigger handle.
To Next Page
Loading...
