GreenWorks GPW2000 User Manual (English)

Questions and Answers:

B
benjamin62Aug 4, 2025
Why does my GreenWorks GPW2000 Pressure Washer have low pressure?
- D
  danapalmerAug 4, 2025
  There are several reasons why your GreenWorks Pressure Washer might not be reaching high pressure: * The diameter of your garden hose may be too small. Try replacing it with a 1” (25 mm) or 5/8” (16 mm) garden hose. * Your water supply could be restricted. Check your garden hose for any kinks, leaks, or blockages. * The water supply may not be sufficient. Make sure to open the water supply fully. * The spray tip might not be properly installed on the spray wand. Ensure the desired spray tip is correctly installed at the end of the wand. * The water intake filter could be clogged. Remove the filter and rinse it in warm water.
H
hmcneilAug 14, 2025
What to do if my GreenWorks Pressure Washer won't start?
- N
  Nathaniel TrujilloAug 14, 2025
  If your GreenWorks Pressure Washer motor isn't starting, consider these possible causes: * The power button may be in the "OFF" (O) position. Set the power switch to the “ON” ( | ) position. * The power cord may not be plugged in. Connect the power cord to the power supply. * The electrical outlet might not be supplying sufficient power. Try another electrical outlet. * The circuit breaker could be tripped. Let it cool, and start the machine again. * The power switch may be on, but you are not pulling the spray gun trigger. Pull the spray gun trigger.
D
Dr. Daniel WilsonAug 23, 2025
What to do if my GreenWorks GPW2000 pressure goes up and down?
- G
  Gary WatsonAug 23, 2025
  If the output pressure of your GreenWorks Pressure Washer varies high and low, it could be due to several factors: * Insufficient water supply: Open the water supply fully and check the garden hose for kinks, leaks, or blockages. * Air in the pump: Ensure all hoses and fittings are airtight. Turn the machine off and purge the pump by squeezing the trigger gun until a steady flow of water comes out of the spray tip. * Clogged water intake filter: Remove the filter and rinse it in warm water. * Low supply voltage: Ensure that only the pressure washer is running on the circuit. * Calcification: Run distilled vinegar through the detergent tank.

GreenWorks GPW2000 Specifications

General

Maximum Pressure	2000 PSI
Flow Rate	1.2 GPM
Motor	13 Amp
Hose Length	25 ft
Power Cord Length	35 ft
Power Source	Electric
Voltage	120V
Nozzle Types	25°, Soap

Summary

DESCRIPTION

PURPOSE

Details the intended use of the pressure washer for cleaning vehicles, boats, and driveways for domestic purposes.

OVERVIEW

Provides a labeled diagram identifying all major components of the pressure washer.

GENERAL POWER TOOL SAFETY WARNINGS

Outlines essential safety precautions for operating the pressure washer, emphasizing user responsibility and safe practices.

ELECTRICAL SAFETY WARNINGS

Covers crucial electrical safety measures, including proper extension cord use and protection against electrocution.

PRESSURE WASHER SAFETY WARNINGS

Specific safety instructions for pressure washer operation, including handling discharge streams and proper maintenance.

EXTENSION CORDS

Guidelines for selecting and using appropriate extension cords for outdoor electrical appliances.

CHILD SAFETY

Emphasizes the importance of child supervision and safe operation around children.

SYMBOLS ON THE PRODUCT

Explains the meaning of various symbols found on the product to ensure safe and proper usage.

RISK LEVELS

Defines signal words like DANGER, WARNING, and CAUTION to communicate potential hazards and their severity.

PROPOSITION 65

Informs users about chemicals known to the state of California to cause cancer or reproductive harm.

INSTALLATION

ELECTRICAL CONNECTION

Instructions for connecting the machine to a suitable power supply, specifying voltage and frequency requirements.

UNPACK THE MACHINE

Steps for safely unpacking the pressure washer and its components from the packaging.

INSTALL THE GUN HOLDER

Guides on how to attach the gun holder to the upper handle of the pressure washer.

INSTALL THE UPPER HANDLE

Instructions for assembling the upper handle onto the main body of the pressure washer.

INSTALL THE WHEELS

Details on how to attach the wheels to the pressure washer frame for mobility.

INSTALL THE SPRAY WAND

Steps for connecting the spray wand securely to the pressure washer gun.

INSTALL THE HIGH PRESSURE HOSE

Instructions for connecting the high-pressure hose to the machine and the spray gun assembly.

OPERATION

CONNECT THE WATER SUPPLY TO THE MACHINE

How to properly connect the garden hose to the water inlet for operation.

USE THE GUN

Guidance on operating the spray gun trigger, including safety lock and release mechanisms.

CHANGE THE NOZZLE

Procedures for safely changing the spray nozzle to suit different cleaning tasks.

ADD DETERGENT

Instructions for adding detergent to the machine's detergent tank for cleaning applications.

START THE MACHINE

Steps to safely start the pressure washer after all connections are made.

STOP THE MACHINE

Procedures for safely shutting down the pressure washer and releasing residual pressure.

MAINTENANCE

NOZZLE MAINTENANCE

Guidance on cleaning and maintaining the spray nozzles to ensure optimal performance.

TRANSPORTATION AND STORAGE

MOVE THE MACHINE

Safety tips and procedures for safely moving the pressure washer from one location to another.

STORE THE MACHINE

Instructions for proper storage of the pressure washer, including drying and protection.

TROUBLESHOOTING

TECHNICAL DATA

LIMITED WARRANTY

EXPLODED VIEW

Related product manuals

GreenWorks GPW2000-1

13 pages

GreenWorks GPW2000-1RBSC

GreenWorks GPW 2000-1

3 pages

GreenWorks GPW2000 User Manual

Table of Contents

Questions and Answers:

GreenWorks GPW2000 Specifications

Summary

DESCRIPTION

PURPOSE

OVERVIEW

GENERAL POWER TOOL SAFETY WARNINGS

GENERAL POWER TOOL SAFETY WARNINGS

ELECTRICAL SAFETY WARNINGS

PRESSURE WASHER SAFETY WARNINGS

EXTENSION CORDS

CHILD SAFETY

SYMBOLS ON THE PRODUCT

RISK LEVELS

PROPOSITION 65

INSTALLATION

ELECTRICAL CONNECTION

UNPACK THE MACHINE

INSTALL THE GUN HOLDER

INSTALL THE UPPER HANDLE

INSTALL THE WHEELS

INSTALL THE SPRAY WAND

INSTALL THE HIGH PRESSURE HOSE

OPERATION

CONNECT THE WATER SUPPLY TO THE MACHINE

USE THE GUN

CHANGE THE NOZZLE

ADD DETERGENT

START THE MACHINE

STOP THE MACHINE

MAINTENANCE

NOZZLE MAINTENANCE

TRANSPORTATION AND STORAGE

MOVE THE MACHINE

STORE THE MACHINE

TROUBLESHOOTING

TECHNICAL DATA

LIMITED WARRANTY

EXPLODED VIEW

Related product manuals