NOTE
Make sure that you put the cutting line in the slot on
the new spool and extend the line approximately 15
cm before you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing.
8. Push the spool cover until it clicks into position.
5.4 REPLACE THE CUTTING LINE
Figure 15 - 22.
NOTE
Use only with the nylon cutting line of 1.65 mm
diameter.
1. Simultaneously press the tabs on both sides of the
trimmer head and remove the spool cover.
2. Remove the spool.
3. Remove the remaining cutting line on the spool.
Replace spool if it is worn or damaged.
4. Cut two pieces of cutting line approximately 3m long
of each.
5. Bend one end of the line 1/4 of an inch
(approximately 6mm) and insert the line into the
anchor hole of the spool.
6. Wind the cutting lines around the spool uniformly
and tightly in the indicated direction.
NOTE
Failure to wind the line in the indicated direction will
cause the bump head to operate incorrectly.
7. Insert the end of the cutting line into the guide slot.
8. Put the spool in the spool housing.
9. Put the end of the cutting line through the eyelet and
extend approximately 15 cm to release it from the
guide slot in the spool.
10. Install the spool cover onto the spool housing.
6 TRANSPORTATION AND
STORAGE
6.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
7 TROUBLESHOOTING
Problem Possible Cause Solution
The ma-
chine does
not start
when the
trigger is
pushed.
No electrical
contact between
the machine and
the battery pack.
1. Remove battery
pack.
2. Check contact and
install the battery pack
again.
The battery pack
is depleted.
Charge the battery
pack.
The lock-out but-
ton and trigger
are not pushed
at the same
time.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to
start the machine.
7
English
EN
To Next Page
Loading...
