1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. You cannot use the machine to cut or
chop hedges, shrubs, bushes, flowers and compost.
1.2 OVERVIEW
Figure 1 - 22.
1
Trigger
2
Lock-out button
3
Rear handle
4
Auxiliary handle
5
Upper shaft
6
Coupler
7
Lower shaft
8
Cut-off blade
9
Edge guide
10
Trimmer head
11
Guard
12
Screw
13
Hex wrench
14
Release button
15
Positioning hole
16
Metal ring
17
Knob
18
Battery release button
19
Spool retainer button
20
Spool cover
21
Spool
22
Tab
23
Hole
24
Spool housing
25
Anchor hole
26
Slot
A
Direction of roatation
B
Best cutting area
C
Dangerous cutting area
2 SAFETY
WARNING
Make sure that you follow all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
WARNING
Remove the battery pack from the machine before
installation.
WARNING
Do not use accessories that are not recommended for
this machine.
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If parts of the machine are damaged, do not use
the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
WARNING
For your personal safety, do not insert battery before
the tool is assembled completely.
3.2 ATTACH THE EDGE GUIDE
Figure 2 - 3.
NOTE
The edge guide can limit the cutting range of the
machine and decrease the risk of the damage caused
by the rotating cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
3.3 ATTACH THE GUARD
Figure 4 - 5.
WARNING
Do not touch the cut-off blade.
4
English
EN
To Next Page
Loading...
