GreenWorks GD60BCB - 8 Troubleshooting

8 TROUBLESHOOTING
Problem Possible Cause Solution
The machine does not
start when the trigger is
pushed.
No electrical contact between the
machine and the battery pack.
1. Remove battery pack.
2. Check contact and install the battery pack
again.
The battery pack is depleted. Charge the battery pack.
The lock-out button and trigger are
not pushed at the same time.
1. Pull the lock-out button and hold it.
2. Pull the trigger to start the machine.
The machine stops
when you are cutting.
The guard is not attached to the ma-
chine.
Remove the battery pack and attach the guard to
the machine.
Heavy cutting line is used. Use only with the nylon cutting line of 2.0 mm /
2.4 mm diameter.
The grass winds around the motor
shaft or the trimmer head.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and
trimmer head.
The motor is overloaded. 1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as the
load is removed.
3. When you cut, move the trimmer head in and
out of the grass to be cut and remove no more
than 20 cm in pass.
The battery pack or machine is too
hot.
1. Cool the battery pack until its function returns
to normal.
2. Cool the machine for approximately 10 mi-
nutes.
The battery pack is disconnected
from the tool.
Install the battery pack again.
The battery pack is depleted. Charge the battery pack.
The line does not ex-
tend.
Lines are welded to themselves. Lubricate with silicone spray.
Not enough line on the spool. Install more line.
Lines are worn and too short. Extend the line.
Lines are tangled on the spool. 1. Remove the lines from the spool.
2. Wind the lines.
9
English
EN