EasyManua.ls Logo

GreenWorks GPW 2000 - Detergent Flow Problems; Hose and Tip Leaks

GreenWorks GPW 2000
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 26
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Detergent is not coming
out.
Detergent is too thick. Dilute detergent.
Filter on detergent
suction tube is
clogged.
Run warm water through lter to remove build-
up.
Damaged or clogged
detergent suction
tube.
Remove obstruction or replace detergent
suction tube.
Spray tip is
obstructed.
Blow out or remove debris with a fine needle.
Garden hose connection
leaks.
Loose connection. Tighten connection.
Missing/worn rubber
washer.
Insert new washer.
Spray wand, extension, or
spray tip leaks.
Broken o-ring or
plastic insert.
Call the Toll-Free Helpline.
Pump is noisy.
Pump is sucking air.
Check that hoses and ttings are airtight. Turn
off machine and purge pump by squeezing
trigger gun until a steady ow of water emerges
through the spray tip.
Water filter is clogged. Remove water lter and rinse in warm water.
Water leaks from pump.
Loose fittings. Check that all ttings are tight.
Water seals are
damaged or worn.
Call the Toll-Free Helpline.
Oil is dripping.
Oil seals are damaged
or worn.
Call the Toll-Free Helpline.
Soap does not come
out or comes out at low
pressure.
75 degree tip / Soap
Tip (Black color) is not
installed in wand.
Install 75degree, black, soap tip in wand.
Soap tank may be
plugged with debris or
thick soap.
Empty soap from tank, clean out using vinegar
and water.

Related product manuals