EN - 16
OPERATION
To add detergent:
■ Place pressure washer upright on a flat surface
■ Remove cap from detergent tank
■ Pour detergent into tank
■ Reinstall cap
C A U T I O N :
Use only approved pressure washer cleaners. Do not use bleach, chlorine,or any cleaners containing
acids.
To use:
■ Connect low pressure black soap spray tip to the wand connector.
(See Figure 8-2.)
■ Squeeze the trigger and the detergent will automatically be mixed with the water and dispensed from
the spray tip.
NOTE: Use a funnel, if needed, to prevent accidental spilling of the detergent outside the tank. If any
detergent is spilled during the filling process, make sure the unit is cleaned and dried before proceeding.
Detergent
Fig. 8-1
Use Black Soap Tip Only
Fig. 8-2
To Next Page
Loading...
