EN - 22
MAINTENANCE
QUICK WINTERIZING PROCEDURE
If you cannot do the Optimum Winterizing procedure, you can still protect your pressure washer from
winter damage by doing below:
■ Disconnect all water connections.
■ Turn on the machine for a few second, until the remaining water in the pump exits. Turn off immediately.
■ Do not allow high-pressure hose to become kinked.
■ Store the machine and accessories in a room that does not reach freezing temperatures. Do not store
near furnace or other sources of heat as it may dry out the pump seals.
C A U T I O N :
Drain gun assembly of any remaining water. Aim gun downwards and squeeze trigger.
SHUTTING DOWN AND CLEANING UP
■ (If you are not using detergent, go directly to Step 2.) When you have finished using the detergent
injection system, fill detergent bottle with clean water. Siphon water at low-pressure for one minute so
that all detergent is flushed through system. Remove detergent bottle and rinse it thoroughly.
■ Disconnect the garden hose from the water inlet on the unit.
■ Press trigger to release any remaining water pressure.
■ Turn the switch to "OFF" (0) position.
■ Unplug the power cord from the outlet.
■ Engage gun safety lock.
TAKING A BREAK
If taking a break of ve minutes or more.
■ Engage gun safety lock.
■ Turn unit to “OFF” (O) position.
■ Unplug the power cord from the outlet.
I M P O R T A N T :
The use of a pump protector is recommended when storing to help prevent a against freezing over the
winter months. It also help prevent the seals from drying out while sitting in storage in all climates.
To Next Page
Loading...
