8 INSTALLATION
WARNING
Do not use accessories that are not recommended by the
manufacturer.
WARNING
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
9 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
WARNING
For your personal safety, do not insert battery before the
tool is assembled completely.
10 UNFOLD AND ADJUST THE
HANDLE
1. Pull up and back the upper handle to lift the handle into
operating position.
2. Tighten the lower handle with quick-release levers on the
two sides.
ATTENTION
Make sure that the two handles are in the same position.
WARNING
Do not make damage to the cables when you fold or unfold
the handle.
11 INSTALL THE UPPER HANDLE
1. Align the holes in the upper handle and the lower handle.
2. Put the cam locks through the holes.
3. Tighten the knobs onto the cam locks.
4. There are two positions (P) available to choose while
installing the upper handle.
5. Do the same operation on the other side.
WARNING
Use caution when installing upper handle to avoid potential
finger pinches.
9
English
EN
To Next Page
Loading...
