GreenWorks STF309 - English; Default Chapter; Table of Contents

1 Description.........................................4
1.1 Purpose.............................................................. 4
1.2 Overview........................................................... 4
2 Important safety instructions...........4
3 Symbols on the machine................... 5
4 Risk levels...........................................5
5 Service................................................ 6
6 Environmentally safe battery
disposal...............................................6
7 Installation......................................... 6
7.1 Unpack the machine.......................................... 6
7.2 Attach the edge guide........................................ 7
7.3 Attach the guard.................................................7
7.4 Assemble the shaft.............................................7
7.5 Attach the auxiliary handle................................7
7.6 Install the battery pack.......................................8
7.7 Remove the battery pack................................... 8
8 Operation........................................... 8
8.1 Start the machine............................................... 8
8.2 Stop the machine............................................... 8
8.3 Operation tips.................................................... 8
8.4 Cutting tips........................................................ 9
8.5 Adjust the length of the cutting line.................. 9
8.6 Adjust the length of the cutting line
manually............................................................ 9
8.7 Adjust the cutting diameter................................9
8.8 Change to the edging mode............................... 9
8.9 Adjust the length of the shaft...........................10
9 Maintenance.....................................10
9.1 General information.........................................10
9.2 Clean the machine........................................... 10
9.3 Replace the spool.............................................11
9.4 Replace the cutting line....................................11
10 Transportation and storage............ 11
10.1 Store the machine.............................................11
11 Troubleshooting...............................12
12 Technical data..................................12
13 Limited warranty............................ 13
14 Exploded view..................................14
3
English
EN