GreenWorks STG404 Original Instructions

189 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

P0802941-02

P0802941-02

技术要求：

2.188P , 内容见电子档；

3.单黑印刷，保持色块始终朝外，要求无色差、无污点；

4.胶装，裁切均匀、无连页；

5.以封样为准。

6.料件需符合格力博HSF文件《有害物质管理标准》里关于环保和有害物质的具体要求。

1.材质要求：封面封底120g双胶纸（4P），内页60g双胶纸（184P），85%本白；

常州格力博集团

说明书

陈丽

周艳

向叶春

李金涛

23.7.18

A B

B

版本号

是否专业款

工艺

审核

校对

设计

标记

处数

签名

日期

阶段标记

视角标记

重量比例

批准

审定

标准化

日期

更改文件号

210mm

145mm

GWK 60V String Trimmer

2108307

N

祁婷婷

@设变前料号P0802941-01，改地址人名等

重要度等级

B

Table of Contents

Other manuals for GreenWorks STG404

Operator's Manual188 pages

Questions and Answers:

J
John LambAug 21, 2025
Why doesn't my GreenWorks STG404 Trimmer start when I push the trigger?
- S
  Sarah WallaceAug 21, 2025
  If your GreenWorks Trimmer doesn't start when you push the trigger, here's what to check: * Make sure there's good electrical contact between the trimmer and the battery. Remove the battery, inspect the contact points, and then reinstall the battery securely. * The battery pack might be empty. Try charging it. * Ensure you're pressing the lock-out button and the trigger simultaneously. First, pull and hold the lock-out button, then pull the trigger to start the trimmer.
R
Rebecca WellsAug 26, 2025
How to fix a GreenWorks STG404 Trimmer when the line does not advance?
- J
  Jaime GrossAug 26, 2025
  Here's how to address a GreenWorks Trimmer line that won't advance: * If the lines are stuck together, try lubricating them with silicone spray. * If there's not enough line on the spool, install more line. * If the lines are worn too short, advance the cutting line. * If the lines are tangled on the spool: 1. Remove the lines from the spool. 2. Rewind the lines neatly.
P
phamjohnAug 28, 2025
Why does the line keep breaking on my GreenWorks Trimmer?
- D
  Daniel WhiteAug 28, 2025
  If the line on your GreenWorks Trimmer keeps breaking, it might be due to incorrect usage. Try these tips: * Cut with the tip of the line, and avoid hitting stones, walls, or other hard objects. * Advance the cutting line regularly to maintain a full cutting width.
D
Dr. Mark StewartAug 30, 2025
How to stop grass from winding around the trimmer head of my GreenWorks STG404?
- J
  Jesse WilliamsAug 30, 2025
  To prevent grass from winding around the trimmer head and motor housing of your GreenWorks Trimmer, avoid cutting tall grass at ground level. Instead, cut tall grass from the top down, removing no more than 8 inches in each pass.
T
Tara AlvaradoSep 1, 2025
What to do if my GreenWorks STG404 line does not cut well?
- B
  bhallSep 1, 2025
  If the line on your GreenWorks Trimmer isn't cutting well, the cut-off blade may be dull. Sharpen the cut-off blade with a file or replace it.
C
Charles GreenSep 3, 2025
Why is the vibration on my GreenWorks STG404 Trimmer increasing?
- T
  Taylor ObrienSep 3, 2025
  If the vibration of your GreenWorks Trimmer increases noticeably, it could be because the line is worn down on one side and hasn't been advanced. Ensure the line on both sides is normal and advance the line.
J
Jeffrey HendricksSep 5, 2025
Why GreenWorks Trimmer does not start?
- T
  Tiffany DavisSep 6, 2025
  If your GreenWorks Trimmer doesn't start when you push the trigger, there could be a few reasons. First, check that the battery pack is making good electrical contact with the trimmer by removing and reinstalling it. Also, make sure the battery isn't depleted – if it is, charge it. Finally, ensure you're pressing the lock-out button and trigger simultaneously to start the trimmer.
W
Wendy MooreSep 8, 2025
What to do if GreenWorks STG404 Trimmer stops when cutting?
- L
  Laura RamseySep 8, 2025
  If your GreenWorks Trimmer stops while you're cutting, it could be due to a couple of things. First, make sure the guard is properly attached to the machine; remove the battery pack before attaching the guard. Also, ensure you are using the correct cutting line diameter (2.0 mm/2.4 mm).
H
holdenjenniferSep 10, 2025
What to do if GreenWorks STG404 battery pack is disconnected?
- J
  Jacob TuckerSep 10, 2025
  If the battery pack is disconnected from the GreenWorks Trimmer, reinstall the battery pack again.
D
Deborah HurstSep 10, 2025
How to fix GreenWorks Trimmer line that does not extend?
- J
  Jason KennedySep 12, 2025
  If the line on your GreenWorks Trimmer isn't extending, several factors could be at play. The lines might be stuck together; try lubricating them with silicone spray. You might not have enough line on the spool, so try installing more. The lines could be worn and too short, in which case, extend the line. Or, the lines might be tangled on the spool; remove them and wind them again.

GreenWorks STG404 Specifications

General

Type	String Trimmer
Battery Voltage	40V
Cutting Width	13 inches
Runtime	Up to 60 minutes
Power Source	Battery
Battery Included	Yes
Charger Included	Yes
Cutting Path	13 inches
Line Diameter	0.065 in

Related product manuals

Preview: GreenWorks STG401

GreenWorks STG401

Preview: GreenWorks STG307

GreenWorks STG307

Preview: GreenWorks STG310

GreenWorks STG310

GreenWorks STG308

Preview: GreenWorks STG309

GreenWorks STG309

GreenWorks STF306

Preview: GreenWorks STA805

GreenWorks STA805

Preview: GreenWorks STF456

GreenWorks STF456

Preview: GreenWorks ST24B01

GreenWorks ST24B01

Preview: GreenWorks ST80L210

GreenWorks ST80L210

Preview: GreenWorks ST24B210

GreenWorks ST24B210