GreenWorks UTV800 - Failure Code

22
FAULT CODE
0041 Throttle Wiper High 1.Throttle failure.
2.Check the connections of Throttle.
0042 Throttle Wiper Low 1.Throttle failure.
2.Check the connections of Throttle.
0043 Pot2 Wiper High 1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
0044 Pot2 Wiper Low 1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
0045 Pot Low Overcurrent 1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
0046 EEPROM Failure Cycle KSI.
0047 HPD/Sequencing Fault Reapply input s in correct sequence.
0048 Emer Rev HPD Reapply input s in correct sequence.
0049 Parameter Change Fault Cycle KSI.
0053 HPD Fault Reapply inputs in correct sequence.
0054 Battery BMS Fault 1.Check the battery voltage ;
2.Restart vehicle;
3.Replace battery and contact dealer.
0055 BMS PDO Fault Cycle KSI
0056 Battery Cell UnderVoltage
Fault
Cycle KSI
0068 VCL Run Time Error Edit VCL application software to x this error condition;
ash the new compiled software and matching
parameter defaults; cycle KSI.
0069 External Supply Out of Range Bring the external supply current within range.
0071 OS General Cycle KSI.
0072 PDO Timeout Cycle KSI or receive CAN NMT message.
0073 Stall Detected Stalled motor.
Motor encoder failure
0077 Supervisor Fault Check for noise or voltage drift in all switch inputs;
check connections;cycle KSI.
0078 Supervisor Incompatible Load properly matched OS code or update the
Supervisor code; cycle KSI.
0087 Motor Characterization Fault Correct fault; cycle KSI.
0088 Encoder Pulse Error Ensure the Encoder Steps parameter matches the
actual encoder; cycle KSI.
0089 Motor Type Fault Set Motor_Type to correct value and cycle KSI.
0091 VCL/OS Mismatch Download the correct VCL and OS software into the
controller.