- 37 -
1) Press the switch (fig. 17, ref. D) until the warning light lights up.
2) Loosen the PTO belt stretcher by turning the corresponding lever (fig. 17, ref. A) and
remove the belt from the cutting deck pulley.
3) Carry out points 1-2-3 listed in the paragraph "CUTTING DECK TILTING".
4) When the cutting deck frame wheels lift from the ground, stop the tilting and put the cutting
height indicator in position "2" (fig. 2, no. 10).
5) Disconnect the connector of the electrical system (fig. 20, ref. A).
6) Lift the red safety hooks (fig. 18, ref. A).
7) Catch the cutting deck frame frontally and remove it from its place.
Attention! Never unlock the switch (fig. 17, ref. D) when the cutting device is off. The cutting
deck fixing arms could violently hit the upper part of the machine with the risk of damaging
things or people close to the machine.
To connect the cutting device back to the machine:
1) Approach the hinges to the hooks by lifting and setting them into their groove.
2) Tighten the red safety hooks (fig. 16, ref. B) and connect the electrical system connector
(fig. 20, ref. A).
3) Turn the ignition key into "ON" (without starting the engine). Unlock the switch (fig. 17,
ref. D); the warning light has to be off.
4) Set the PTO belt into the pulley on the deck and tighten it by turning the corresponding
lever (fig. 17, ref. A).
5) Lower the mobile foot rest platform (fig. 13, ref. B) and fix the cutting deck with the
corresponding red locking levers (fig. 14, ref. A).
PTO BELT
Attention! This is a special belt, USE ORIGINAL BELTS.
To replace it, loosen the tie rod by acting on the corresponding lever (fig. 17, ref. A) and
remove the belt from the pulley on the cutting deck. Loosen the electromagnetic clutch
protection (fig. 21, ref. A) and let it slide towards the rear part of the machine. In this way it
is possible to remove the belt completely from the electromagnetic clutch.
To set the tension use a no. 13 spanner to turn the nut that adjusts the tension spring (fig.
19, ref. B).
The spring must be compressed to a length of 85 mm.
To Next Page
Loading...
Need help?
General
