20. Feed the cable over the pulleys in the black
box.
21. Fasten the black box to the top of the filter.
22. Feed the cable through the gasket and box
plate, then fasten the box plate to the black
box.
24. Pull the left side of the cable down until it
stops, and secure the stop bead up against
the handle holder.
23. Secure the stop bead on the right side of the
cable, approximately 12" from the end.
25. Loop the right side of the cable through a
handle, and pull the handle down to cinch the
cable tight.
To Next Page
Loading...
Need help?
General
