To Next Page

To Previous Page

-12-

Model G0458 (Mfg. Since 5/11)

Inventory

Box 1: (Figures 3 & 4) Qty

A. Drum Sander .............................................. 1

B. Dust Bag ..................................................... 1

C. Dust Hose Clamp ....................................... 1

D. Dust Port .................................................... 1

E. Stand Legs ................................................. 4

F. Bottom Long Brackets ................................ 2

G. Top Long Brackets ..................................... 2

H. Bottom Short Brackets ............................... 2

I. Top Short Brackets ..................................... 2

Figure 3. Box Contents.

Figure 4. Additional box contents.

J. Hardware and Tools (Not Shown)

— Handwheel ............................................ 1

— Handwheel Handle M10-1.5 ................... 1

— Phillips Head Screw M6-1 x 25 .............. 1

— Flat Washer 5mm .................................. 1

— Hex Bolt M8-1.25 x 20 ........................... 4

— Hex Nut M8-1.25 ................................... 4

— Flat Washer 8mm .................................. 8

— Carriage Bolt M8-1.25 x 15 .................. 24

— Serrated Flange Nut M8-1.25 .............. 24

— Combination Wrench 8/12mm ............... 1

— Hex Wrenches 4, 5, 6mm ................ 1 ea

The following is a list of items shipped with your

machine. Before beginning setup, lay these items

out and inventory them.

If any non-proprietary parts are missing (e.g. a

nut or a washer), we will gladly replace them; or

for the sake of expediency, replacements can be

obtained at your local hardware store.

NOTICE

If you cannot find an item on this list, care-

fully check around/inside the machine and

packaging materials. Often, these items get

lost in packaging materials while unpack-

ing or they are pre-installed at the factory.

Grizzly G0458 Owner's Manual

Other manuals for Grizzly G0458