Grizzly G0704 Installation Instructions

28 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Schlumberger-Private

Installation

Instructions for the

Grizzly G0704

WWW.HEAVYMETALCNC.COM

Other manuals for Grizzly G0704

Owner's Manual61 pages

Questions and Answers:

E
Eric PenningtonAug 26, 2025
Why is my Grizzly G0704 Drill breaking cutters?
- M
  mccallkentAug 26, 2025
  Your Grizzly Drill might be breaking tools or cutters due to: * Spindle speed being too slow, or the feed rate being too fast. * Cutting tool getting too hot. Use coolant fluid or oil for appropriate application. Follow cutting fluid manufacturer's recommendation for proper use and safety. * Taking too big of a cut. Decrease depth of cut. * Spindle extended too far down. Fully retract spindle and lower headstock to increase rigidity.
M
mollyhamiltonAug 27, 2025
What to do if Grizzly G0704 Drill workpiece vibrates?
- M
  Michael DiazAug 27, 2025
  If the workpiece vibrates or chatters during operation with your Grizzly Drill: * Ensure the table locks are tight. * Tighten the quill lock lever. * Check that the workpiece is securely clamped to the table or in the mill vice. Make sure the mill vice is tight to the table. * Adjust the spindle speed to be correct or use a slower feed rate. * Fully retract the spindle and lower the headstock to increase rigidity.
P
pateltimothyAug 29, 2025
How to improve Grizzly Drill surface finish?
- O
  ojacksonAug 29, 2025
  To improve the surface finish with your Grizzly Drill: * Adjust the spindle speed to be correct or use a slower feed rate. * Sharpen the cutting tool or select one that better suits the operation. * Check for proper cutting rotation for the cutting tool. * Secure the workpiece properly to the table. * Fully retract the spindle and lower the headstock to increase rigidity.
E
Eugene HartmanAug 31, 2025
What to do if Grizzly Drill tool slips?
- M
  michaelrussoAug 31, 2025
  If the tool slips in the collet of your Grizzly Drill: * Tighten the drawbar, as the collet may not be fully drawn up into the spindle taper. * Measure the tool shank diameter and match it with an appropriate diameter collet, as the wrong size collet may be in use. * Clean the collet and spindle taper to remove any debris. * Lessen the depth of cut and allow chips to clear, as you might be taking too big of a cut.

Grizzly G0704 Specifications

General

Motor	1 HP, 110V, Single-phase
Spindle Taper	R-8
Max Spindle Speed	2500 RPM
Model	G0704
Category	Drill
Spindle Travel	2"
Spindle Speed	50-2500 RPM
Table Tilt	45° Left/Right
Speed Range	50-2500 RPM

Related product manuals

Preview: Grizzly G0705

Preview: Grizzly G0781

Preview: Grizzly G0761

Preview: Grizzly G0758

Preview: Grizzly G7947

Preview: Grizzly G7943

Preview: Grizzly G7948

Preview: Grizzly G1199

Preview: Grizzly G9749

Preview: Grizzly G1006

Preview: Grizzly G1005Z

Preview: Grizzly NPT FOUND G4014

Grizzly NPT FOUND G4014