Grizzly G0708 - Inventory

Model G0708 (Mfd. Since 1/15)
-11-
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Box 1: (Figure 3) Qty
A. Dust Collector Assembly w/Filter ............... 1
B. Cabinet ....................................................... 1
C. Spare Door Seal
3
⁄8" x 1" x 79" ................... 1
D. Teflon Tape ................................................. 1
E. Legs ............................................................ 4
F. Left Door..................................................... 1
G. Right Door .................................................. 1
H. Side Leg Supports...................................... 2
I. Blast Tip Set ............................................... 1
—Blast Tip 6mm ID
.................................... 2
— Blast Tip 7mm ID .................................... 2
J. Canister Plunger Assembly ........................ 1
K. Hopper Chute Door w/Metering Valve ........ 1
L. Lever and Latch Set (for 2-Doors) .............. 1
M. Viewing Window Dust Sheets 23
1
⁄2" x 10" . . 5
N. Lamp Window Dust Sheets 21
1
⁄2" x 4" ....... 5
O. Bolt Bag ...................................................... 1
—Cabinet Screws
1
⁄4-20 x
1
⁄2" ................... 26
— Flange Nuts
1
⁄4"-20 ................................ 26
P. Spare Front Door Seal
1
⁄4" x
3
⁄4" x 79" ........ 1
Figure 2. Inventory.
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
B
C
D
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi-
als to eliminate choking/suf-
focation hazards for children
and animals.
A
E
L
N
M
H
G
J
I
F
K
O
P