Grizzly G1015 Parts List

Name: Grizzly G1015
Brand: Grizzly
Rating: 4 (1 reviews)

5 pages

To Next Page

KNIFE BELT SANDER/BUFFER

MODEL G1015

PARTS LIST

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

REVISED OCTOBER,1999. PRINTED IN U.S.A.

PARTS LIST DISCLAIMER

This parts list and drawings represent the configuration of the machine as it is currently being shipped. The machine configuration can change as product

improvements are incorporated. If you own an earlier version of the machine, this parts list may not depict your machine exactly. Contact Customer Service

if you have any questions about part differences. Previous parts list versions are not available on-line.

Other manuals for Grizzly G1015

Owner's Manual40 pages

Instruction Manual25 pages

Questions and Answers:

R
Ray SmithJul 25, 2025
What to do if my Grizzly G1015 Sander does not start?
- J
  Jack ObrienJul 26, 2025
  If your Grizzly Sander doesn't start or a breaker trips, it could be due to several reasons. First, make sure the power supply is switched on and has the correct voltage. Check the plug and receptacle for good contacts and correct wiring. A faulty start capacitor may also be the cause, so test and replace if necessary. If the wall circuit breaker tripped, ensure the circuit size is correct and replace any weak breakers. Inspect the wiring for any broken, disconnected, or corroded wires. The motor ON/OFF button or the centrifugal switch could also be at fault and may need replacement. Finally, the motor itself could be faulty and may require testing, repair, or replacement.