To Next PageTo Next Page
Need help?Do you have a question about the Grizzly G1013 and is the answer not in the manual?
General| Belt Size | 6" x 48" |
|---|---|
| Disc Diameter | 9" |
| Disc Speed | 1725 RPM |
| Motor | 1 HP |
| Voltage | 110V/220V |
General safety guidelines for operating power tools, emphasizing proper use and precautions.
Specific safety precautions for sander operation, covering belt/disc contact and material handling.
Important warnings about tool familiarity, attention, protective gear, and operational caution.
Details on operating the sander with a 110V power supply, including amperage draw.
Recommended fuse or circuit breaker rating for the sander's electrical circuit protection.
Guidelines for selecting and using appropriate extension cords with the sander.
Explanation of the importance of grounding for safety and proper connection.
Introduction to the Grizzly Model G1013 Combination Sander and its capabilities.
Details on Grizzly's contact info, e-mail, website, and policy on product improvements.
Crucial warning to read the manual before assembly and operation to prevent injury.
Describes the assembly process and tools required for the sander.
Step-by-step instructions for assembling the sander components.
Instructions for adjusting the sander belt for proper tracking and alignment.
Procedure for adjusting the tilt angle of the belt table.
Steps for removing and installing a new sanding belt.
Procedure for adjusting the tilt angle of the disc table.
Steps for removing and installing a new sanding disc.
Pre-operation checks and initial run procedure for the sander.
Instructions for performing general sanding operations on the belt and disc.
Technique for sanding curved surfaces using the belt.
Method for sanding interior work areas using the belt.
Procedure for using the sander for sharpening tasks with an auxiliary table.
Routine checks for wear and tear on the sander components.
Guidance on lubricating the sander's roller shafts.
Advice on protecting and maintaining the sander's working tables.
A log for recording maintenance performed on the sander.
Details on the product warranty, return policy, and customer support.
Recommendations for further resources to maximize the machine's potential.
Final safety warnings regarding proper use, modifications, and operational risks.
