-20- G1013 Combination Sander
SECTION 7: MAINTENANCE
General
Table
Your combination sander is equipped with shield-
ed and pre-lubricated ball bearings that require
no lubrication for the life of the bearings. All bear-
ings are common sizes and are readily available
from a local bearing supply house or our Service
Department. The roller shafts, however, will ben-
efit from regular applications of light machine oil.
See Figure 23.
The working table and other non-painted sur-
faces on the Model G1013 should be protected
against rust and pitting. Wiping the sander clean
after every use ensures that sawdust is not
allowed to trap moisture against bare metal sur-
faces.
Tables can be kept rust-free with regular applica-
tions of products like Boeshield
®
T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit™.
Make a habit of inspecting your sander each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Worn or damaged V-belt.
5. Poor belt tensioning ⁄ tracking.
Figure 23. Lubrication points.
Lubrication
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
To Next Page
Loading...
Need help?
General
