Grizzly G8027 User Manual

Model G8027 (Mfd. Since 09/23)
-21-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE
section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the safety disabling mechanism on the ON/OFF
switch works correctly.
To test run machine:
1.
Clear all setup tools away from machine.
2. Connect machine to dust collection system or
cover inlet.
IMPORTANT: DO NOT operate dust collec-
tor without first connecting it to dust collection
system or covering inlet. Otherwise, lack of
airflow resistance will cause motor to operate
at full amperage load, which could trip your
circuit breaker or blow fuse.
3.
Connect machine to power.
4. Use ON/OFF switch to turn machine ON (see
Figure 22), verify motor operation, and then
turn machine OFF.
Motor should run smoothly and without
unusual problems or noises.
5.
Remove switch disabling key from ON/OFF
switch, as shown in Figure 23.
6.
Try to start machine with ON/OFF switch.
Machine should not start.
— If machine does not start, switch disabling
feature is working correctly.
— If machine does start, immediately stop
machine. Switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with reg-
ular operations. Call Tech Support for
help.
Figure 23. Removing switch key from ON/OFF
switch.
Figure 22. Location of ON/OFF switch.
ON/OFF Switch

Grizzly G8027 Specifications

General

Brand	Grizzly
Model	G8027
Category	Dust Collector
Language	English