24
7. MAINTENANCE, STORAGE, AND SERVICE
7.1 MANTENANCE AND STORAGE SAFETY
• Always observe safe refueling and fuel handling practices when refueling the unit after transportation
or storage.
• Always follow the engine manual instructions for storage preparations before storing the unit for both
short and long term periods.
• Always follow the engine manual instructions for proper start-up procedures when returning the unit to
service.
• Never store the machine or fuel container inside where there is an open ame, such as in a water
heater. Allow unit to cool before storing.
• Shut off fuel while storing or transporting. Do not store fuel near ames or drain indoors.
• Keep all hardware tight and keep all parts in good working condition. Replace all worn or damaged
decals.
• Never tamper with safety devices. Check their proper operation regularly.
• Disengage spreader spinner and sprayer pump, set parking brake, stop engine and remove key or
disconnect spark plug wire. Wait for all movement to stop before adjusting, cleaning or repairing.
• Clean grass and debris from moving parts, drives, mufers, and engine to prevent res. Clean up oil
or fuel spillage.
• Let engine cool before storing and do not store near ame.
• Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting.
• Park machine on level ground. Never allow untrained personnel to service machine.
• Use jack stands to support components when required.
• Carefully release pressure from components with stored energy.
• Disconnect battery or remove spark plug wire before making any repairs. Disconnect the negative
terminal rst and the positive last. Reconnect positive rst and negative last.
• Keep hands and feet away from moving parts. If possible, do not make adjustments with the engine
running.
• Charge batteries in an open well ventilated area, away from spark and ames. Unplug charger before
connecting or disconnecting from battery. Wear protective clothes and use insulated tools.
• Check brake operation frequently. Adjust and service as required.
• Use only factory authorized replacement parts when making repairs.