63
GB
Cleaning and maintenance
Caution!
• AlwaysputthemainswitchintheOFFposition
before performing any form of cleaning or
maintenance on the robot lawnmower.
• Wearworkglovestoavoidcuttingyourselfonthe
blades.
• Makesurethatnowaterpenetratestherobot
lawnmower. The robot lawnmower must not be
rinsed or washed in running water.
The robot lawnmower should be cleaned regularly.
Wipe the exterior of the robot lawnmower with a damp
cloth.
Clean the robot lawnmower’s charging socket and the
charging poles on the charging station with a small
brush or similar, and remove any dirt or deposits with a
small piece of very ne sand paper.
Adjust the cutting height to the lowest setting and turn
the robot lawnmower upside down.
Clean the cutting disc and the blades using a soft brush
or a damp cloth with a mild detergent, if necessary.
Check that the cutting disc can rotate freely.
Remove grass clippings, soil and mud from the wheels.
If any of the parts on the robot lawnmower are
damaged, worn or defective, they must be replaced
with the corresponding original parts.
The blades last for about three months provided that
there is no contact with obstacles. Always replace all
three blades at the same time so that the cutting disc is
in balance.
Use a screwdriver to dismantle the blades and to screw
the new ones on.
Check that the blades can move around these screws
once they are tted to the cutting disc.
The robot lawnmower is equipped with a maintenance-
free lithium-ion battery.
If the robot lawnmower will not be used for a prolonged
period, the battery should be charged fully once every
three months.
Winter storage
The robot lawnmower, charging station and power
supply must be put into winter storage at the end of the
season and before the frosty weather arrives. The parts
must be stored in a clean, dry and frost-free place.
Clean the robot lawnmower as described above.
Lubricate the blades with a lubricating spray or similar.
Charge the battery manually (see “Manual charging”
under point 7) Charging error
Push the on/o switch to OFF.
The boundary wire can be left in the garden, but its
connections should be protected with insulating tape
and waterproof grease or similar to prevent corrosion.
Remember to charge the battery manually at least every
three months while the robot lawnmower is in storage.