Grouw! 17935 User Manual

53
GB
Installation
You can nd installation videos and tips at www.grouw.
dk.
The robot lawnmower’s operation
The robot lawnmower’s work area must be surrounded
by the boundary wire, which must form a continuous
loop around the area to be mowed.
The robot lawnmower runs in a random pattern within
the work area and changes direction whenever it
detects the boundary with its sensors, and each time it
encounters an immovable obstruction. This ensures that
the entire lawn is cut without leaving a pattern of wheel
tracks on it.
Once the robot lawnmower has registered the boundary
wire X times, it moves a few metres away from the most
recent registration point and runs around in a spiral
trajectory to improve its coverage of the lawn.
When the robot lawnmower needs charging, it
automatically follows the boundary wire back to the
charging station.
Planning
It is important that you carefully consider how the
boundary wire is laid out so that you encircle all the
obstacles such as beds, terraces, trampolines, shrubs
and trees, ponds and paths in your garden.
We recommend that you make a sketch of your garden
and mark the location of the charging station and the
boundary wire before you start laying it out.
If you follow the instructions above and take the time
required, it is not dicult to lay out the boundary wire.
Note! If your neighbour has a similar robot
lawnmower, there must be a clearance of at least
160 cm in all directions between your neighbour’s
boundary wire and your own! If your neighbour has a
robot lawnmower of a dierent make, you may need
an even greater distance, as the frequency in the
boundary wires are dierent.
Step 1: Installing the charging station
First nd out where in the garden the charging station
should be placed.
• Theinstallationpointmustbeclosetoanoutdoor
electrical socket that the charging station can be
connected to.
• Theinstallationpointmustbenexttothelawn.The
boundary wire that runs from the charging station
must be fed under the charging station so that its
end returns to the rear of the charging station. The
other end of the boundary wire must be fed to the
rear of the charging station.
• Theinstallationpointmustbeatanddryandthere
must be no obstructions 2 metres in front of the
charging station and 1 metre behind it. The charging
station should not be placed in a corner, as there
is a risk that the robot lawnmower will get stuck
between the corner and the charging station.
• Theinstallationpointmustbeintheshademost
of the day, as it is best not to charge the robot
lawnmower’s battery in direct sunlight where the
temperature may get too high. If necessary, purchase
a garage for the robot lawnmower so that it has
some cover when it is not cutting the grass.
• Theinstallationpointmustbefreeofantnestsand
the like to prevent insects getting into the charging
station.

Grouw! 17935 Specifications

General

Brand	Grouw!
Model	17935
Category	Lawn Mower
Language	English