Growatt New Energy Australia Pty Ltd
C1, 27-29 Fariola Street,
Silverwater NSW 2128
(6) Fill in RS232-to-USB cable’s COM port number in “COM:” field.
Set inverter’s COM address by knocking to inverter’s knock control panel (please refer to
the manual), and fill the address in “InvAdd” field.
Fill in the set value in “Set value” field. We suggest to change “14. R1 Vac High” value to
5v higher, thus is 268v.
(7) Click “Operate” to apply the change. Once inverter accepted, it would show “Set OK” in
“Set Result” filed.
(8) Tick the “Read” checkbox, and click “Operate” to read and check the change.
To Next Page
Loading...
