20) Align the BOTTOM (K1) with its tracks, arrow facing
front, and slide into place. Stand the assembly upright.
21) Run the 2-pin connector and wires from the WIRING
HARNESS through the opening of the LED PANEL (I)
and plug into the LED board connector. Then align the
LED PANEL (I) with its tracks and slide into place.
22) Move all wiring aside
towards the top of the cabinet
and insert the CENTER BRACE
(J) into its tracks with the opening
at the back, and slide it forward.
(continued)
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...