10.2 Guided setup
After the pump is connected to Grundfos GO, we
recommend that you follow the guided setup in
Grundfos GO.
The guided setup helps you to select the optimal
settings for the current system. By choosing the
optimal settings, you can lower the energy
consumption and prevent potential noise
problems.
If you select Use default settings, the pump uses
the factory setting, valve mode AUTOADAPT.
10.3 Flow limitation
You can set a minimum and maximum flow rate in
Grundfos GO.
A minimum flow limit can be set to prevent the
boiler from overheating. A maximum flow limit can
be set to prevent noise in the system.
10.4 Trend data
In the Trend data menu in Grundfos GO, you can
see system data for the last 10 or 100 on-cycles.
An on-cycle is the period from when the pump
turns on until it turns off. If the pump runs
continuously for more than 24 hours, one on-cycle
is registered and a new on-cycle will start even
though the pump has not yet turned off. The 100
cycles view consists of 10 observations where
each observation is the average of 10 on-cycles.
You can see the following data:
• Duration of each on-cycle
• Flow
• Head
• Estimated media temperature.
You can use the trend data for system
optimization and fault finding.
10.5
Updating the software
Follow the steps below to update the product’s
software via Grundfos GO:
1. Make sure your smart device has sufficient
power.
2. Make sure your smart device is connected to
the internet.
If there is no internet where the pump is
installed, go to step 3 and then follow the
instructions in Grundfos GO.
3. Connect your product to Grundfos GO if it is
not already connected.
The app automatically checks if the product
has the latest software installed. If a newer
version is available, the text New software
available appears on the dashboard in
Grundfos GO. You can also check for software
updates in the Settings menu.
4. Follow the guide in Grundfos GO to install the
software update.
10.6 Resetting to factory settings
The product can be reset to factory settings in two
ways:
• Via Grundfos GO
1. Open Grundfos GO.
2. Press the gear icon in the top right side of
the screen.
3. Go to the Factory reset menu and press
Reset.
• Via the operating panel
1. Press and hold the unit icon for 5 seconds.
17
English (US)
To Next Page
Loading...
