Make sure that only one module is connected when
setting the GENIbus number.
1. Enter the new number in the line "GENIbus number".
2. Press [OK] to broadcast the number.
3. Disconnect the module and connect the next one, if several
modules need a new number.
Path: Settings > Communication settings > Fieldbus addresses
4-3-2_GENIBUS_NUMBER_028
Fieldbus addresses
Related information
8.3.5 Ethernet
8.6.7 Fieldbus addresses
8.3.7
SMS numbers
Telephone numbers for alarm SMS and the SCADA system are
entered in this display.
It is possible to enter three alarm SMS numbers and one SCADA
system number.
SMS numbers
The SMS numbers are used with the schedule to send SMS-
message-enabled warnings or alarms.
These SMS numbers are also used for SMS authentication.
See section about SMS authentication.
SCADA number
The SCADA number is used for SCADA callback when CU 362 has
a SCADA-callback-enabled warning or alarm.
Send alarm SMS to
An alarm SMS can be sent in three different ways:
• Primary number only
• Primary and secondary numbers
• First primary then secondary number if not acknowledged.
Acknowledgement deadline
This deadline is the time allowed for the user of the primary number
to acknowledge an alarm SMS before the SMS message is sent to
the secondary number.
Example
Enter the desired telephone numbers for the alarm SMS and
SCADA system.
Enter digits using the [Plus] and [Minus] buttons. Go to next digit
using the [Up] and [Down] buttons. Press [OK] to save the number.
SMS numbers
• No 1 +4512345678
• No 2 +4511223344
• No 3 +4599988877.
SCADA number
• +4512345678.
Acknowledgement deadline
The time allowed to pass before the alarm SMS is sent to the
secondary number is ten minutes.
Path: Settings > Communication settings > SMS numbers
4-3-3_SMS_NUMBERS_072
SMS numbers
Related information
8.3.3 CIM 250/260 (Modbus and SMS via GSM/GPRS)
8.3.4 CIM 270/280 GRM (Grundfos Remote Management)
8.3.10 SMS authentication
8.3.8
SMS schedule
The SMS schedule, meaning the alarm SMS phone number and the
message timing, is set in this display.
Select day of the week
When a day has been selected, the three periods of the day can be
set:
• Work
• Off
• Sleep.
To enable the period, tick the box and enter the starting point of the
period.
The settings for the selected day apply to all three periods.
Shift change
A shift change can also be set in the schedule. Schedule periods
serve practical purposes, for example, to avoid sending SMS
messages about minor faults to the service manager in the middle
of the night. The service manager receives the SMS messages
when returning to work. Three different shift change times can be
set for any 24-hour period. Every shift change can be set with both
a primary and a secondary telephone number.
A shift change can take place in the middle of a period.
View SMS schedule
This function is used to call up a graphical overview of the SMS
schedule.
Select one of the graphical overviews:
• Work/Off/Sleep
• Primary recipients
• Secondary recipients.
See the graphical illustrations below.
Path:
Settings > Communication settings > SMS schedule
52
English (GB)
To Next Page
Loading...
