Grundfos CU 362 - Page 66

8.6.5 Password
In this display, it is possible to limit the access to the menus
"Operation" and "Settings" by means of a password.
If the access is limited, it is not possible to view or set any
parameters in the menus.
A password must consist of four digits.
If you have forgotten your password, contact Grundfos.
Factory setting
Both passwords are disabled. Factory setting is "1234".
Path: Settings > General settings, CU 362 > Password
TM078743
Password
8.6.6 Ethernet
See section about Ethernet.
Related information
8.3.5 Ethernet
8.6.7
Fieldbus addresses
See section about fieldbus addresses.
Related information
8.3.6 Fieldbus addresses
8.6.8
Software status
This display shows the version of the software installed in CU 362.
In this display, it is possible to upgrade the software using the
Grundfos CU 362 Firmware Upgrader Box. See the installation and
operating instructions for the CU 362 Firmware Upgrader Box on
the CD-ROM supplied with the Dedicated Controls control cabinet.
Path:
Settings > General settings, CU 362 > Software status
TM077343
Software status
66
English (GB)