Grundfos Hydro Multi-E 2 CRIE 5-9 U2 A-A-A-A User Manual

English (GB)
44
29. Factory settings
1)
Only available if an advanced functional module, type FM 300, is fitted.
2)
Active if inlet sensor is fitted from factory.
3)
Not active if inlet sensor is fitted from factory.
● Function is enabled.
❍
Function is disabled.
- Function is not available.
Settings
CRE CME
"Setpoint" 30 % of sensor range 30 % of sensor range
"Operating mode" "Normal" "Normal"
"Control mode" "Constant pressure" "Constant pressure"
"Pipe filling function" "Not active" "Not active"
"Buttons on product" "Active" "Active"
"Stop function" (Low-flow stop function) "Active" "Active"
"Controller" (Controller settings) ● ●
"Ti" 0.5 0.5
"Kp" 0.5 0.5
"Operating range" 25-100 % 25-100 %
"Ramps"
"Ramp-up" 1 second 1 second
"Ramp-down" 3 seconds 3 seconds
"Number" ("Pump number") - -
"Radio communication" "Active" "Active"
"Analog input 1" "4-20 mA" "4-20 mA"
"Analog input 2" "Not active" "Not active"
"Analog input 3" "Not active"
2)
-
1)
"Pt100/1000 input 1" "Not active" -
1)
"Pt100/1000 input 2" "Not active" -
1)
"Digital input 1" "External stop" "External stop"
"Digital input 2" "Not active" -
1)
"Digital in/output 3" Dry running
3)
Dry running
3)
"Digital in/output 4" "Not active" -
1)
"Pulse flowmeter"
❍❍
"Predefined setpoints" "Not active" "Not active"
"Analog output" "Not active" -
1)
"External setpoint function" "Not active" "Not active"
"Signal relay 1" "Ready" "Ready"
"Signal relay 2" "Running" "Running"
"Limit 1 exceeded" "Not active" "Not active"
1)
"Limit 2 exceeded" "Not active" "Not active"
"LiqTec" "Not active" -
1)
"Standstill heating" "Not active" "Not active"
"Motor bearing monitoring" "Active" "Active"
"Pump name" Hydro Multi-E Hydro Multi-E

Grundfos Hydro Multi-E 2 CRIE 5-9 U2 A-A-A-A Specifications

General

Brand	Grundfos
Model	Hydro Multi-E 2 CRIE 5-9 U2 A-A-A-A
Category	Extender
Language	English