10
MOTOR CONTROl VIA KEYPAD
The Redi-Flo VFD can operate the motor in three (3) different ways from the keypad.
1. Speed adjustment using the Keypad arrow keys
2. Speed adjustment with Keypad entered values
3. JOG Command
1) Keypad arrow speed control
Press FWD, then press or hold the up arrow key to increase speed or use the down arrow key to reduce
motor speed. Continuously holding the arrow key will cause the speed to change in larger increments.
2) Keypad speed entered value
Press the ENTER key and use the keys to adjust digits and the keys to cursor to the desired digit.
Press ENTER when finished selecting desired motor speed to return to the display mode. Press and release the
FWD key to run the motor in the desired direction at the programmed speed. Press STOP to stop the pump.
3) JOG Command
The JOG key can be used to ramp the pump up to a predetermined speed in the forward or reverse direction.
Press the JOG key then hold the FWD key, and the pump will ramp to the speed set in PROG/Jog Settings/Jog
Speed. The pump will continue to run until the FWD key is released.
MENU/ESC key - Advanced Programming
For advanced programming features, please refer to the full programming guide found at the Baldor website:
www.Baldor.com The manual can be found under Support – installation and operation manuals. It is Baldor
manual number MN740, Series H2 Inverter.
s
s
s
s
s
s
To Next Page
Loading...
Need help?
General
