Grundfos RSI Series - Operation and Control; Control Panel Overview

English (GB)
9
5. Operation
5.1 Control panel
The Renewable Solar Inverter control panel is shown
in fig. 6 below. The control panel has four LEDs, a
digital display and nine operating keys.
Fig. 6 Control panel layout
Warning
Check all electrical connections before
powering up the system.
Warning
The heat sink becomes hot during running
and stays hot for a long time. Touching it
while it is hot will cause burns.
Caution
In case of altitudes over 1000 m, the
output current should be reduced by 10 %
for every 1500 m increase in altitude.
Note
Adjust control parameters according to the
steps indicated in this manual before the
first start.
TM05 4446 2412
Digital display control panel
Operating keys
(The function of the keys is shown in the
table below.)
Mode indicator lights (LEDs):
On
RUN
FLT (FAULT)
Ready
Indicator lights and keys Function description
On On indicator light Yellow On: Inverter is on.
Run Run indicator light Green On: Inverter is running.
FLT Fault indicator light Red On: System fault.
Ready Ready indicator light Yellow On: System is ready to run.
Return key
Returns to previous screen in the control panel and is
used to reset faults.
Home key Returns to home screen in the control panel.