Grundfos S Series - Raising the Pump to Upright Position

English (GB)
4
4.2.2 Lifting points (bottom)
S pumps, ranges 66 and 70, are equipped with a lifting bracket on
the motor top cover and on the lower bearing bracket. See fig. 2.
Fig. 2 Lifting points for installation type H
4.3 Raising the pump to upright position
Carelessness during the lifting or transportation may cause injury
to persons or damage the pump.
Fig. 3 Raising the pump to upright position, step 1
Fig. 4 Raising the pump to upright position, step 2
Fig. 5 Raising the pump to upright position, step 3
TM06 5922 0316
DANGER
Crushing hazard
Death or serious personal injury
- Make sure the lifting bracket or the strap is
tightened before attempting to lift the pump.
Tighten if necessary.
DANGER
Crushing hazard
Death or serious personal injury
- Do not stand under or next to the pump when
raising it to upright position in order to avoid
crushing in case the pump overturns.
- Make sure the pump is raised gently into upright
position to avoid the lifting chain slipping off the
crane when the pump is not in balance.
TM03 3034 0208
Lifting points
TM03 3035 0208TM03 3036 0208