Automatic restart of SBA pumps
SBA pump models with a float switch automatically
restart when water is added. Models without a float
switch will attempt to restart every 24 hours.
Related information
9.1.1 Flow rate
9.1.4 Pressure
5. Handling and storing the product
5.1 Handling the product
Do not lift the product by the power cable.
Lift the product by means of a rope.
Do not drop or shake the product.
5.2 Storing the product
Store the product indoors in a dry and dust-free
environment. Protect the product from vibrations.
Storage temperature: -10 to +40 °C.
5.3 Frost protection
It the pump is not used during periods of frost, drain
the pump and the pipe system before you take the
pump out of operation.
6. Product introduction
6.1 Product description
The pumps are submersible booster pumps available
in two main versions:
• pump with integrated inlet strainer with 1 mm
mesh
• pump with side inlet, which includes a flexible inlet
hose with floating inlet strainer with 1.8 mm mesh.
Both versions are available with or without float
switch. The float switch can be used for automatic
operation or dry-running protection of the pump.
6.2 SB pumps
The SB submersible booster pump is available with
integrated inlet strainer or floating inlet strainer. The
SB pump must be connected to an external controller,
see section Connecting to external controller.
Related information
3.6.2 Connecting to external controller
6.3 SBA pumps
The SBA pump is a complete submersible booster
pump available with integrated inlet strainer or
floating inlet strainer.
SBA has a built-in control unit, eliminating the need
for a controller.
The pump has built-in protection against overheating.
Related information
3.6.2 Connecting to external controller
6.4
SBA dry-running protection
The built-in control unit incorporates dry-running
protection that automatically stops the pump in case
of dry running.
The dry-running protection functions differently during
priming and operation.
11
English (GB)
To Next Page
Loading...
Need help?
General
