Grundfos SEG - Receiving the Product; Transporting the Product; Handling and Lifting the Product; Installing the Product

3. Receiving the product
Before installation, carry out the following checks:
• Make sure the product corresponds to the order.
• Make sure the pump is suitable for the supply
voltage and frequency available at the installation
site.
• Make sure the accessories or any other
equipment are intact.
3.1 Transporting the product
The pump may be transported and stored in a
vertical or horizontal position.
CAUTION
Crushing hazard
Minor or moderate personal injury
‐ Make sure the pump cannot roll or fall
over.
3.2 Handling and lifting the product
All lifting equipment must be rated for the purpose
and checked for damage before lifting the pump. The
lifting equipment rating must not be exceeded. The
pump weight is indicated on the nameplate.
WARNING
Crushing hazard
Death or serious personal injury
‐ Do not stack pump packages or pallets
on top of each other when lifting or
moving them.
‐ Always lift the pump by its lifting
bracket or by a forklift truck if the pump
is fixed on a pallet. Never lift the pump
by the power cable, hose, or pipe.
CAUTION
Sharp element
Minor or moderate personal injury
‐ Wear protective gloves when opening
the pump package.
Keep the cable end protectors in storage
for later use.
DANGER
Crushing hazard
Death or serious personal injury
‐ Make sure that the lifting bracket is
tightened before lifting the pump.
WARNING
Crushing hazard
Death or serious personal injury
‐ When lifting the pump, make sure your
hand cannot be caught between the
lifting bracket and the hook.
WARNING
Crushing hazard
Death or serious personal injury
‐ Make sure that the hook is fixed
properly to the lifting bracket.
‐ Always lift the pump by its lifting
bracket or by a forklift truck if the pump
is fixed on a pallet.
‐ Never lift the pump by the power cable,
hose, or pipe.
‐ Make sure that the lifting bracket is
tightened before lifting the pump.
When lifting the pump, use the right lifting point to
keep the pump balanced. Place the lifting chain hook
in point A for auto-coupling installations and in point B
for other installations.
TM060066
Lifting points
4. Installing the product
Do not install the pump more than 2000
metres above sea level.
All work in pits must be supervised by a person
outside the pit.
Compliance with the standard EN
60079-14 is a customer responsibility.
Pump installation in pits must be carried
out by specially trained persons.
Work in or near pits must be carried out
according to local regulations.
10
English (GB)