Need help?Do you have a question about the Grundfos Sololift2 C-3 and is the answer not in the manual?
General| Product Name | Grundfos Sololift2 C-3 |
|---|---|
| Category | Water Pump |
| Max Head | 8.5 m |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Inlet Size | DN40 |
| Protection Class | IP44 |
| Outlet Size | DN 32 |
| Temperature Range | 5 - 50 °C |
| Liquid Temperature | 0°C to 90°C |
| Approvals | VDE |
Explains DANGER, WARNING, and CAUTION symbols and their meaning.
Details special symbols like Ex, mandatory actions, prohibitions, and tips.
Describes the SOLOLIFT2 C-3 as a compact automatic lifting station for grey wastewater.
Details suitable uses for domestic grey wastewater and restrictions on commercial use.
Specifies acceptable pH, temperature, and limitations on chemicals for pumped liquids.
Provides warnings and instructions for safe handling and stacking during transport.
Covers placement, pipe material, insulation, and vibration prevention for mechanical setup.
Details safety requirements for electrical connection, including RCD and main switch.
Provides information on where to find service documentation and contact support.
Recommends checks for operation, pipe connections, float switch, and carbon filter replacement.
Provides steps for removing dirt from the impeller and operating the unit with a power drill.
Lists causes like supply failure, stuck impeller, or tripped thermal switch, with remedies.
Addresses causes like a stuck impeller or defective motor/capacitor, with remedies.
Covers issues like water leaking into the tank or a defective float switch.
Explains blockages in the pump/tank or outlet pipe as causes for low flow.
Lists causes like long outlet pipes, excessive bends, or leaky pump housing.
Identifies a foreign body hitting the impeller as the cause for rattling noise.
Attributes tank odor to a contaminated carbon filter and suggests replacement.
Covers blocked hydraulics, changed start level, or small inlet pipe diameter as causes.
To Next Page
