ENGLISH
34
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
3 Select your preferred language by pressing
»
« or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Date/Time« menu opens.
4 Select the hour format »12« or »24« by press-
ing »
« or » « or by turning the Volume Knob
and confirm by pressing »OK«.
– Display: »Auto update« menu opens.
5 Select the input source from which the automat-
ic time synchronisation should be performed.
Selection options:
– »Update from DAB«;
– »Update from FM«;
– »Update from Network«;
– »No update« (No automatic time synchroni-
sation).
6 Select one of the options by pressing »
« or
»
« or by turning the Volume Knob and con-
firm by pressing on the Volume Knob or »OK«
on the remote control.
– The menu »Set timezone« appears (only if
»Update from Network« was selected).
Note:
7
If »Update from DAB« or »Update from FM«
was selected, continue from point 9.
7 Select the time zone by pressing »
« or » «
or by turning the Volume Knob and confirm by
pressing »OK«.
– Display: »Daylight savings« menu opens.
8 Select Daylight savings (for Central Europe) by
pressing »
« or » « or by turning the Volume
Knob to select »ON«, and confirm by pressing
»OK«.
Normal time is set using »OFF«.
– The menu »Internet Setup« appears.
9 If the device is to be switched on via the network,
select the »YES« button with »
« or » « or by
turning the jog shuttle and confirm with »OK«.
If the device is not to be switched on (low
stand-by power), select the »NO« button with
»
« or » « or by turning the jog shuttle and
confirm with »OK«.
– The menu »Wlan region« appears.
10 Select one of the WLAN regions by pressing
»
« or » « or by turning the Volume Knob
and confirm by pressing »OK«.
(This setting depends on the location where
you are operating your Cosmopolit 4.)
– The »SSID« menu appears, and the available
networks (access points) are displayed.
Notes:
7
If the connection to the router is via a
WLAN, there are two options, depending
on the router in use: If the router supports
[WPS], then continue operation from step
10/11 or step. 10/12.
If the router does not support [WPS], then
continue operation from step 13.
7
If the network name (SSID) is suppressed on
the WLAN router for security reasons, the
network cannot be found. It must then be en-
tered manually. Select the option »[Manual
config]« with »
« or » « or by turning the
Volume Knob and press »OK« to confirm.
Continue with the chapter “Special Settings”
– “Registering the device ...” (see "Long
manual").
11 Select your wireless [WPS] network with
»
« or » « or by turning the Volume Knob
and press »OK« to confirm.
Note:
7
There are two options for logging on to a
[WPS] network: using the push button on the
router or by entering a PIN on the router.
12 S elect the option »Push-Button« with »
« or
» « or by turning the Volume Knob and press
»OK« to confirm.
Activate the »Push Button« function on the
router (menu or button) and press »OK« on
the device within 2 minutes.
– Display: »Please wait, connecting« and
then »Connected«.
End setting with »OK« on the device;
or
To Next Page
Loading...
