EasyManuals Logo

Grundig GNU 41820 X User Manual

Grundig GNU 41820 X
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
10
DISHWASHER / USER INSTRUCTIONS
/55 EN
Installation
min
300
min
120
max 1000
min 500
Do not use old or used water inlet hose
on the new product. Use the new water
inlet hose supplied with the product.
Connect the water inlet hose directly
to the water tap. Pressure coming from
the tap should be minimum 0.3 and
maximum 10 bars. If the water pressure
exceeds 10 bars, a pressure relief valve
should be installed in between.
Open the taps completely after making
the connections to check for water leaks.
C
Use a screw-on hose connector
to connect the water inlet hose
to a water tap with a ¾ inch
external thread. If required, use
a filter insert to filter deposits
from the pipes.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection must
be min. 50 cm and max. 100 cm from the
floor. A discharge hose longer than 4 meters
causes dirty washing.
Attach the water discharge hose to the
drainpipe without bending it. Tightly fix the
water discharge hose to the drainpipe in
order to prevent any dislocation of the water
discharge hose during operation of the
product.
C
Drainpipe must be connected to
the sewage system and it should
not be connected to any surface
water.
Adjusting the feet
If the door of the product cannot be closed
properly or if the product swings when
you push it slightly, then you need to adjust
the feet of the product. Adjust the feet of
the product as illustrated in the installation
manual supplied with the product.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grundig GNU 41820 X and is the answer not in the manual?

Grundig GNU 41820 X Specifications

General IconGeneral
Door colorStainless steel
Control typeButtons, Touch
Display typeLCD
Built-in displayYes
Appliance placementUndercounter
Control panel colorBlack, Stainless steel
Noise level44 dB
Delay start (max)24 h
Number of place settings13 place settings
Number of washing programs8
Drying classA
Annual water consumption2800 L
Annual energy consumption262 kWh
Water consumption per cycle10 L
Energy consumption per cycle0.92 kWh
Weight and Dimensions IconWeight and Dimensions
Depth548 mm
Width598 mm
Height820 mm

Related product manuals